Dt466 Crank Position Sensor Location. 0410 DT466/570, HT570, MaxxForce DT/9/10 *Crankshaft Position Sensor Coolant drain plug (underneath compressor bracket) location) EGES-265-2 Read all safety instructions in the "Safety Information" section of this manual before doing any. At #1 TDC, Camshaft timing pin will not be seen through the CMP sensor hole
I have a 2004 international. with a dt466. it has a new crank and cam from www.justanswer.com
Engine Mounted Components NOTE: For Water in Fuel (WIF) sensor and optional Engine Fuel Pressure (EFP) sensor location, see "Fuel Flow" in Section 1 (page 35) Coolant drain plug (underneath compressor bracket) location) EGES-270-1 Read all safety instructions in the "Safety.
I have a 2004 international. with a dt466. it has a new crank and cam
The crankshaft position is determined by synchronizing the SYNC tooth with the SYNC gap signals from the target disk We have a 2000 International 4700 with a DT466E Engine The BAP sensor is located in the cab of the vehicle.
I have a 2004 international. with a dt466. it has a new crank and cam. As the cam rotates, the sensor identifies the position of the cam by locating a peg on the cam The crankshaft position is determined by synchronizing the SYNC tooth with the SYNC gap signals from the target disk
International DT466 ELECTRONIC CONTROL SYSTEMS DIAGNOSTICS, 43 OFF. At #1 TDC, Camshaft timing pin will not be seen through the CMP sensor hole REPAIR STEP(s) StepAction Decision #19REPAIR: Reference service manual EGED2652 for front cover removal